Wrapped up @scottestrada94 backhalf last week. We used @kibbetech rear frame rails, fuel cell basket, and trailing arms. @hannaraceanddesign had already built the interior roll cage and left the c pillar/back wall portion of the cage wide open for us to finish out and tie in the backhalf which worked out perfectly. @kdm_shock_technologies valved and sprung the rear shocks. We added some tubes, shock brackets, exhaust, tin, storage, skid plates,bedsides, rear bumper, driveshaft… the list goes on haha. Thank you Scott for having us get this hot rod handled for you 👊🏻
Ol’ F100 is back under the knife! Got her parked over at @dgiannini shop for some more fab and final assembly before we get her over to Scott at JLM to wire the whole truck! Getting excited again 🤣
Couple shots of @broseph4 and myself from Pismo a while back. Motivation to wrench on this thing has been at an all time low. It’s been collecting spiderwebs since KOH. 🤷🏻 📹 @johnnygarner13
LETS FUCKIN GOOOOO!!! 🤘🏽😎🤘🏽
@terracrew squad rippin' the dunes at Pismo.
📸📸📸 | #ijbPOV | 📸📸📸
True to it, Not new to it.
.
itsjustbrian.com
.
#ijbVisuals
.
#AlwaysEvolving
#FueledByPassion
#workHARDstayHUMBLE
@fsi951 66 Mustang build. Chassis, interior roll cage, rear links, sway bar, housing tabbed. Making good progress. Road cars aren’t my normal thing so this has we fun to do so far. Kinda funny how small all the parts are compared to offroad vehicles haha.
Fresh one for @dgiannini built tube chassis. It’s a badass truck with 1,000hp and 4L80 with an underdrive 🤘🏻. Thanks dude.
#4l80 #prerunner #tubechassis #luxuryprerunner #prerunner
@corey_campbell_08 Blazer is wrapped up and headed to wiring. Here’s a rundown of upgrades she received during her time here:
Upgraded the tired old SBC to a brand new 525 LS3
ID Designs accessory drive
Boxed in front frame section, Fabricated new mid & front engine plate mounts, tri-Y headers and exhaust using @magnaflow mufflers
•Removable engine/trans skidplate & structure that ties into I beam mounting brackets
•updated and reworked the dash and center console to house Motec display & PDU, intercom & race radio
And GPS
•New seat mounting brackets, seats & harnesses
•New front bumper
•Updated core support to mount new radiator, and UMP air filters
•Upgraded front hubs to @camburgracing 2.5” snouts/hubs with 14” rotors and new 6piston Wilwood calipers
•New steering box and Ram assist mounts
•All new plumbing throughout.
•Probably some other stuff that has escaped my memory haha.
Thank you Campbell family for allowing my shop to work on your hot rods!! 👊🏻
