Post 2 of 2
Now that you know the story of the pickup plate, here's the rest of the run down.
I wish I had remembered to take a before picture, but of course, I must have just went right into complete disassembly in preparation for the work ahead.
The first step was drawing up specifications for the pickup mounting plate, then routing the middle pickup position in relation to the draw up. After the route work, I shielded all cavities with nickel super shield paint. Once that was all dry, it was time to get all the wiring prepped and installed. Two Emerson Pro 500k audio pots for the volumes (with treble bleed circuits for both), an Alpha 500k audio push/pull for the neck/middle coil tapping, and a CTS 500k audio push/pull for the bridge pickup coil tapping. An Emerson 0.022uf for the bridge tone, and an Emerson 0.015uf for the neck/middle tone. The first mini switch is a three position switch that sends either the neck, the middle, or both at the same time to the main pickup switch neck position. The second mini switch is a phase switch for the bridge pickup. For the pickups, Sam went with
@sonicpickups #crystalpalace neck and middle set, paired with a #sonicpickups #firebird bridge pickup. After that was done (and tested well). It was time to lightly relic the hardware in a tumbler (after taping off all threading). While the parts were tumbling, I removed the stop bar tailpiece holes, glued in dowels, and followed by finish touch up and leveling.
After cleaning up and installing all hardware back in place, it was just a matter of a #fretlevel and #setup
This thing is powerhouse of tonal options, and I can't wait to hear what
@samplecker does with it in the future!
#luthiery #luthier #luthierlife #karrikercustoms #loothing #loothersbeloothin #gibson #gibsonlespaul #gibson50slespaul #emerson #emersonelectronics #cts #switchcraft #bigsby #bigsbytremolo #sonicpickupscrystalpalace #sonicpickupsfirebird #samplecker #vistakicks #pulgajams #dimples