Precision Engine Machine Co

@precisionengine

301-779-5808 Celebrating over 55 years of building horsepower. Family owned and operated with three generations of engine builders.
Followers
49.9k
Following
472
Account Insight
Score
40.94%
Index
Health Rate
%
Users Ratio
106:1
Weeks posts
More EPC X58 motors getting ready to be built. Machine work by the best @precisionengine B58 Gen 1 Stage 2 B58 Gen 2 Stage 2 S58 Stage 1
209 11
1 month ago
Finished up a couple B58 and a S58 for 12mm head stud and flame hoops for all the boost! #b58engine #s58bmw
498 8
1 month ago
Turning these counterweights down to balance this @callies_performance LT1 crankshaft
199 1
1 month ago
Another GenIII Hemi getting billet caps. #hemi #enginebuilder #moparornocar #moparornocar🏁
3,707 35
1 month ago
Breaking in some diamonds on the new @rottlercnc H85AX hone. #automation #engineporn #enginebuilder
121 5
1 month ago
Fresh crosshatch in this LT1 after getting some @arpbolts main studs. #lt1
73 1
1 month ago
Here are some pics of a coyote build we just finished up. @dartonsleeves with hoops, @boostlineproducts Rods, @diamondpistons , @total.seal piston rings all held together with @arpbolts fasteners. #readyforboost #coyotemustang
144 3
1 month ago
If the valve seat was so loose that you had to stake it to death then it shoulda been replaced. There is old school then there is lazy and dumb. 🤦 #herculesjxld #chriscraft
155 18
1 month ago
****SOLD**** I have a 2020 Sunnen SV-15 cylinder hone for sale $59k comes with approximately 16 sets of diamonds, some CBNs and plateau brushes will hone cylinders from 2.750-4.622 Located in Hyattsville, Maryland $59,000
106 3
2 months ago
Another upgrade to the shop! More automation, less people 😏
66 7
2 months ago
A group of Austin 1275 heading out. #austin1275 #austinsprite #mgmidget #minicooper1275
30 1
2 months ago
Darton sleeved for all the boost!
92 1
2 months ago